1497 replies to this topic

[oakmere]

Nick did you know there was a new OBD download to help with LS4 throttle issues? V2.7.5

[CHILL Gone DUTCH]

Nick did you know there was a new OBD download to help with LS4 throttle issues? V2.7.5

👍

[NickB787]

am awaiting a spare unit from Joe before I get myself wound up, I see you can read errors but is there anyway to reset with the software I can't find it, pain having to swap to scangauge to reset them

[The Batman]

no point getting wound up bud

[NickB787]

no point getting wound up bud

I not mate don't worry, Ive done too much R&D over the years now to let it worry me, I do it in stages, change for another unit, fault still there then not tb , fault gone tb, :-) besides got some new toys , thank you Mr Vocky

Edited by NickB777, 20 February 2015 - 03:56 PM.

[The Batman]

[CHILL Gone DUTCH]

You reset the faults by Clicking ecu Reset ecu.... Then you get message to prompt removing error codes

Edited by CHILL Gone DUTCH, 20 February 2015 - 04:05 PM.

[CHILL Gone DUTCH]

Always worth using latest download nick V2.7.5

[The Batman]

alot quicker than trying a different tb

[smiley]

Always worth using latest download nick V2.7.5

 

2.7.5.1

[CHILL Gone DUTCH]

Yep your right

[NickB787]

reset it and managed to start it eventually 2500 rpm left it running there second I lift my foot it stalls, error codes. EML return TB related am almost certain.

[The Batman]

Try the new software nick!!!!

[NickB787]

don't worry I did when I went to download on my tablet it showed 7.4 when I checked on the iPad it was7.5 went back to the tablet then showed 7.5 downloaded, updated and tried it runs :-) must have been software related then, I am going for a drive to check, old tb in boot...

[CHILL Gone DUTCH]

Whoop Good stuff nick when you mapping it ? Are you going to map it without water injection ? Did you find how to reset codes in software ?

[The Batman]

 

glad its sorted

[NickB787]

yep found them, said I don't worry anymore, just proved it let it run on the driveway while I setup for a fuel learn session and as I looked up stream.... yep pro alloy either rad or cc rad has a leak, o we'll clam off won't be at the meet in the VX now... thanks for the help everyone and hope you haven't posted the TB yet Joe:-)

[CHILL Gone DUTCH]

No chance joe has already posted it 😂

[The Batman]

 

nick - remove front headlights and you can access all of the jubilee clips for the hoses at the front

[NickB787]

wonder how Peter knew there was an LS4 problem I hadn't informed him as the software was already set up with it in the menu? Joe will send it back with interest, or add it to my spares collection, but then again Techieboy doesn't have one of these...PS the car seemed to rev well.